Getting data off a phone or tablet is harder than from a computer because the storage is soldered in, the whole device is usually encrypted, and every model is built a little differently. A modern phone ties its encryption key to the passcode and to hardware inside the processor, so the data chips alone are often unreadable.
There are several levels of access. A logical extraction asks the working phone to hand over its data, often through backup tools. A file system extraction goes deeper but still needs the device to run. A physical extraction reads the raw memory. When a phone is dead from water, impact or a failed board, technicians may repair the board, or work through test points and debug interfaces such as JTAG, or ISP (in-system programming). Chip-off, where the memory chip is removed and read directly, is a last resort, and on encrypted devices it often yields nothing usable without the key.
What helps most is a screen lock code you remember and a backup in iCloud, Google, or on a computer. Without the passcode, newer phones are very hard to open.
If a phone has been in water, turn it off, don't charge it, and don't put it in rice. Corrosion keeps spreading, and the sooner it is cleaned the better. Keep the SIM and any memory card too.
Advanced · mobile · android · ios
USB Drive Recovery
Recovering data from flash drives and USB devices
A USB flash drive is a small circuit board with a controller chip, one or more NAND flash chips, and a USB connector. Most failures are simple and mechanical: the connector breaks off the board after being bent or yanked while plugged in. Others are electrical, such as a static discharge or a bad port, and some are in the controller or its firmware, often after the drive is removed during a write.
The symptoms differ. A drive that isn't recognized at all points to the connector, controller, or power. A drive that shows up as zero bytes, with a generic name, or with a strange capacity usually means the controller has lost track of the flash. A drive that works but has missing files is more likely to have a file system problem.
Recovery depends on the cause. A broken connector can be resoldered or bypassed. Controller problems can sometimes be repaired with vendor-specific tools. If the controller is dead, technicians can read the flash chips directly and then rebuild the order of the data, which requires working out how that controller scrambled and interleaved it.
If your flash drive acts strangely, don't keep inserting it or let your computer format it when it asks. Never repair it with chkdsk until you have an image.
Intermediate · usb · flash · portable
Memory Card Recovery
SD cards, CF cards, and other memory card recovery
SD, microSD, CompactFlash, and similar cards store data in NAND flash chips with a small controller that handles wear and bad blocks. They are used in cameras, drones, dashcams, and phones, so they are often written to heavily and pulled out at the wrong moment.
Failures fall into a few groups. Logical errors come from interrupted writes, removing the card while the camera is saving, or formatting it by accident. The card shows as empty, asks to be formatted, or lists unreadable files. Physical wear and electrical damage can leave a card that is detected but returns errors, or does not show up at all.
Recovery software often works for logical problems, because photos and videos can be found by their file signatures even without the file system. For cards that are not recognized, labs may read the flash directly, which takes a lot of work because of the way each controller arranges the data.
The most important step is to stop shooting with the card. Don't format it, even if the camera offers to. Use a card reader, not the camera, and save a copy of the card's contents to your computer before trying anything else.
Intermediate · memory card · sd · cf
Android Data Recovery
Recovering data from Android devices
Most Android phones encrypt their storage by default, with keys tied to the screen lock and to hardware inside the phone. So recovery from a broken or locked Android depends heavily on whether you know the lock code and whether the phone can still start.
If the phone works but the screen is damaged, you may be able to mirror it to a monitor, or use a USB mouse through an adapter, and then copy files or run a backup. USB debugging, if it was turned on earlier, allows tools to talk to the phone through ADB. If it was off, the options shrink. Unlocking the bootloader, which some guides suggest, usually wipes the phone, so don't do it to a phone whose data you want.
Check backups first. Google backs up contacts, calendar, and often photos and app data, and many phones sync photos to Google Photos or a manufacturer's cloud. A microSD card, if the phone has one, can be read on its own.
For phones that are dead from water or impact, a technician may repair the board enough to boot it. Reading the memory chip directly is a last resort, and on an encrypted phone it gives nothing useful without the key.
Don't keep guessing the lock code, and don't factory reset. Keep the phone off if it got wet.
Advanced · android · adb · bootloader
iOS Data Recovery
Apple device data recovery challenges
iPhones and iPads encrypt their storage all the time, using keys that are protected by the device's passcode and by a security chip. Apple designed it so that taking the memory out of the phone does not get you data. That makes iOS recovery a different job from recovering a computer.
In practice, the answer usually comes from backups. An iCloud backup or an encrypted backup made with a computer holds most of what matters, and iCloud Photos, Messages in iCloud, and notes may be stored separately. If you still have a phone that works, check Settings and iCloud.com before anything else. If the phone is damaged but turns on, a technician may be able to repair the screen or board so you can enter the passcode and make a backup. Water damage is common, and cleaning corrosion from the board early makes a difference.
If you have forgotten the passcode, there is no ordinary way around it. Repeated wrong attempts disable the device, and erasing it removes the data. Recovery tools that claim otherwise generally work only on older models or particular software versions.
Don't try to restore the device as a fix, because restoring erases it. Keep the phone off if it has been in liquid, and don't charge it. Know your Apple ID password and keep a backup running.
Advanced · ios · encryption · apple
eMMC Recovery
Embedded MultiMediaCard recovery
eMMC is a type of flash storage that comes as a single chip soldered onto the board, with a controller built into the package. It is common in budget phones and tablets, Chromebooks, cheap laptops, cameras, car infotainment systems, and many small gadgets. It works like a memory card that cannot be taken out.
Because it is soldered, a dead device means the data cannot be reached by plugging in a cable. When the phone itself fails, a lab has a few choices. Some boards have test points that allow the chip to be read in place with a special adapter. If those are damaged, the chip can be removed with heat, cleaned, and read in a reader made for its package, which is known as chip-off. The raw dump then has to be assembled and decoded, and many phones encrypt user data with a key that lived in the processor, so the dump may be useless without the working original.
Chip-off is a last resort, because heat can damage the chip and it cannot be undone. Do not try to reflow, heat, or pry at the board yourself. If a phone is water damaged, shut it down and keep it dry. If it still turns on, back it up now.
Advanced · emmc · embedded · chip-off
UFS Recovery
Universal Flash Storage recovery
UFS, or Universal Flash Storage, is the faster flash storage used in many current phones and tablets, and in some cameras and cars. Like eMMC it is a soldered chip with its own controller, but it uses a different interface that can send and receive at the same time, which makes it quicker. Newer phones have moved from eMMC to UFS for that reason.
For recovery, UFS follows the same pattern as other soldered storage, with more difficulty. Reading it needs equipment that speaks the UFS protocol, and a chip lifted from a board needs a matching adapter. Phones from the last several years also encrypt user data with keys tied to the processor and the secure hardware in the device, so a dump of the flash alone may give nothing usable. That is why a recovery attempt depends on the phone model, its software version, and whether it still powers on at all.
For you, the practical points are simple. Keep the phone off if it has been damaged, and charge it only with the original cable if it still responds. If it shows signs of life, back up through the normal route at once. Remember the passcode, since without it encrypted storage stays locked even for a lab. Do not try a factory reset or a flashing tool from the internet.
Advanced · ufs · high performance · multi-lane
iPhone Won't Turn On
Why a dead iPhone needs board repair, not chip removal
An iPhone's storage is soldered to the logic board and encrypted with keys tied to that phone's processor and Secure Enclave. Moving the storage chip to another phone doesn't work; the data stays unreadable.
So when an iPhone won't power on after a drop, water damage, or a failed battery, data recovery means repairing the original board enough for it to boot: replacing failed power components, repairing damaged connections, and other microsoldering work. Once it boots, you unlock it with your passcode and the data is copied off.
Check iCloud first: if iCloud Backup or iCloud Photos was on, much of your data may already be safe. Bring the phone, its passcode, and any notes on what happened.
Why there's no simple way around a modern passcode
Modern iPhones and Android phones encrypt user data with keys derived in part from your passcode, and they limit how many guesses can be made. After repeated wrong attempts, phones lock out for increasing periods, and some are set to erase themselves.
Without the passcode, the standard ways back into the phone, such as recovery mode or a factory reset, erase the data. For current phones there's no simple service that bypasses the passcode for an owner; be wary of websites that promise one.
Your best options are a cloud or computer backup, and memory: old passcodes, patterns, and whether you changed it recently. Write down what you remember before trying more guesses.
Power the phone off, and don't charge it or plug it into anything. Remove the case and SIM tray, and wipe off the outside. Don't shake it, don't blow into the ports, and don't use rice or heat.
Water-resistant phones are resistant, not waterproof, and their seals age. Salt water, pool water, and sugary drinks cause corrosion faster than fresh water.
If the phone has no recent backup, take it to a repair or recovery professional promptly and say that the data matters. Cleaning the board properly stops corrosion; the longer it sits, the more components may need replacing.
Beginner · water damage · phone · corrosion · first steps
Broken Screen but the Phone Still Works
Getting data off a phone you can't see or touch
A cracked or black screen doesn't mean lost data. If the phone still powers on, rings, or vibrates, the storage is probably fine. The challenge is unlocking it and getting the data out when you can't see or use the display.
Options include checking whether a cloud backup ran recently, connecting it to a computer it already trusts, and having the screen replaced so you can unlock it. A screen replacement keeps your data, but tell the repair shop the data matters so they don't reset or swap the phone.
Try not to let the battery run flat: after a restart, a phone needs its passcode entered before it will share data over USB, which is much harder without a working screen.
Both iPhone and Android photo apps move deleted photos to a holding area first: the Recently Deleted album on iPhone, and the Trash or Bin in Google Photos and many Android gallery apps. Items stay there for a limited time before they're permanently removed.
If iCloud Photos or Google Photos sync is on, deleting a photo on one device deletes it everywhere, but it also lands in the cloud's holding area, so check there too.
Once a photo has left those holding areas on a modern, encrypted phone, recovering it from the phone itself is rarely possible. Look in older backups, computers you've synced with, and messaging apps where you may have sent it.
Many messaging apps keep chat history only on the phone, in an encrypted database, unless you've turned on the app's own backup to iCloud, Google Drive, or a computer. Deleting the app, resetting the phone, or switching phones without transferring can lose that history.
Apps differ. Some sync messages from their servers to any signed-in device; others are end-to-end encrypted and the company never has a copy. Some protect their chat backups with a separate password.
To protect important chats, check the app's backup settings, confirm the date of the last backup, and keep the backup password if there is one. If chats are already lost, look for the app's backup in your cloud account before reinstalling or restoring anything.
Old phones often hold photos that were never backed up. A phone that sat unused for years may have a deeply discharged battery that refuses to charge, or one that has swollen.
Charge an old phone with a suitable charger, and stop if the battery looks swollen or the phone gets hot. If it powers on, back it up right away. Some older phones also have a microSD card with photos on it.
If it won't power on, the problem may be the battery or charging port rather than the storage, and a repair shop can test it with a replacement battery. If you don't remember the passcode, try your old ones; many people used the same one for years.