Data recovery is the work of getting files back from a storage device that you can no longer read normally. The cause decides the method, so the first job is working out what actually went wrong.
Logical problems mean the drive hardware works but the structure that organizes the data is damaged, or files were deleted or a volume was formatted. These are often handled by reading an image of the drive and rebuilding the file system, or by finding files by their content. Physical problems mean something in the device is broken: heads, motor, circuit board, firmware, or flash memory chips. Those need the hardware fixed or bypassed before any data can be read, and for hard drives that can involve opening the drive in a cleanroom. Many failures are a mix of both.
A good process works on a copy. The lab or technician makes a sector-by-sector image of the failing device, then does the analysis on the image so the original takes as little stress as possible.
What you do before handing a device over matters. Stop using it, don't run repair tools or format it, don't open a hard drive yourself, and don't keep power-cycling a drive that makes noises. Write down what happened and what the drive holds, and ask any lab how it handles diagnosis and what it will do with your data.
Beginner · recovery · basics · process
A hard drive's platters are spun and read at a distance from the head to the surface measured in nanometers. A dust particle or a fingerprint is much larger than that gap. Opening a drive in ordinary air lets particles settle on the platters, where they can scratch the surface or stick to a head. A cleanroom, or a clean air workstation, filters the air so far fewer particles are present while the drive is open.
Not every recovery needs one. Logical problems, firmware issues, and circuit board repairs are done with the drive sealed. A cleanroom is needed when the drive has to be opened: replacing failed heads, freeing stuck heads, moving platters into a donor drive, or cleaning debris. Even then, the work needs matching donor parts and a technician who knows that model.
For customers, there are two questions worth asking a lab. First, what does it actually use to open drives, and does it open drives in-house? Some shops that advertise a cleanroom send work elsewhere. Second, what is the stated reason it needs to open your drive? A reasonable lab can explain the diagnosis.
Don't open a hard drive yourself, not even for a quick look. The seal, and the clean air inside it, only comes off once.
Advanced · cleanroom · environment · physical
Drives pulled out of a fire or flood look hopeless, and they often are not. The platters inside a hard drive sit in a sealed housing, and the data on them can survive conditions the outside of the drive does not. What matters is how long the drive was exposed, what it was exposed to, and what happens next.
With water, the main enemy is corrosion and what the water carried. Fresh water that dried slowly leaves less trouble than salt water, sewage, or floodwater, which can leave residue and corrode the circuit board and connectors. If the drive is still wet, don't plug it in. Powering on a damp drive can short the board and drive the heads into a wet platter. Don't dry it with a hair dryer or put it in rice, and don't try to clean it yourself.
With fire, heat can warp parts, melt plastic, and damage the magnetic coating, depending on temperature and time. Smoke and soot are separate problems, because particles can contaminate a drive that was opened or breached.
Keep the device in the condition you found it. Place it in a bag or box that will not crush it, label it, and keep it cool and dry.
Advanced · disaster · fire · water
Data carving is a way of finding files without relying on the file system. Normally, the file system keeps a table that says which sectors belong to which file. When that table is destroyed by formatting, corruption, or damage, carving scans the raw contents of the drive for known patterns instead.
Most file types start with a recognizable signature. A JPEG begins with specific bytes and ends with a particular marker, and the same is true of PDFs, ZIP archives, and many other formats. A carving tool reads through every sector, finds those headers, and cuts out the data that follows until it sees a footer or reaches a size limit.
The method has real limits. Carved files lose their names, folders, and dates, since that information was in the file system. Fragmented files are a bigger problem: if a file wasn't stored in one contiguous run, a simple carver stitches together the wrong pieces, and the result opens as garbage or half a picture.
Run carving on an image, not on the failing drive, and save results to a different drive. Expect to sort through the output and rename files by hand.
Advanced · carving · signatures · forensics
A zero-fill, sometimes called a wipe or a secure erase, writes zeros over the data on a drive. After a complete pass, the original contents are gone from the drive's addressable space. On a modern hard drive, a single overwrite is generally considered enough to prevent ordinary recovery, and no commercial service is known to bring back data from a drive that was fully overwritten.
The idea that special microscopes can read underneath overwritten data comes mostly from old research on early, low-density drives, and it has not been shown to be practical on current ones. Treat a promise to recover a fully zero-filled modern drive with skepticism.
The situation is different if the process stopped early. A wipe that was interrupted leaves everything past the point where it stopped untouched, so a recovery may still find a large part of the data. Quick formats and partition changes, which people often confuse with zero-filling, only rewrite file system structures and leave most data in place. SSDs add another twist, because the drive's own mapping means an overwrite may not hit the same physical flash, and firmware-based secure erase or encryption key deletion can destroy data instantly.
If you started a wipe by mistake, cancel it right away and turn the drive off. The less that has been overwritten, the more is left to recover.
Advanced · zero-fill · overwrite · magnetic
A disk image is a sector-by-sector copy of an entire drive, including deleted files, free space, and file system structures, not just the visible files. Recovery work is then done on the image, leaving the original untouched.
Imaging a healthy drive is straightforward. Imaging a failing one is a specialty: the tools control timeouts and retries, read the easy areas first, skip around damaged zones, and can read one head at a time so a weak head doesn't hold up the rest.
The image becomes the working copy. If anything goes wrong during analysis, the work can start again from the image without asking more of a fragile drive.
Beginner · disk image · imaging · sector copy · failing drive
A clone copies a drive sector by sector onto another drive, producing a disk you can plug in and use directly. An image copies the same sectors into a file, often compressed and with embedded metadata and hashes, which is standard in forensic work.
Clones are convenient for replacing a failing drive. Image files are easier to store, verify, and work with in recovery and forensic tools, and several can sit on one large drive.
Either way, the copy should be verified against the source where possible, and the original kept unchanged. Copying files and folders is not the same thing; it misses deleted data and file system structures.
Intermediate · clone · image file · imaging · forensics
A logical failure means the hardware works but the data is inaccessible: deleted files, a formatted partition, file system corruption, or malware. A physical failure means the device itself is damaged: heads, motor, board, firmware, flash controller, or the storage medium.
The difference determines what's safe. Logical problems on healthy hardware can sometimes be handled with recovery software, working from a copy. Physical problems need the device repaired or stabilized before any data can be read, and software only adds wear.
Many cases are both: a drive with weak heads also develops file system damage. That's why an evaluation starts with the hardware's condition before looking at the files.
Beginner · logical failure · physical failure · diagnosis · recovery
When a hard drive's read/write heads fail, they're replaced in a cleanroom with heads from a donor drive. The donor has to match closely: model, firmware family, number and type of heads, and other manufacturing details that can vary even within one model number.
Even with a well-matched donor, replacement heads are a temporary means of reading the platters, not a repair. The drive is imaged once, carefully, and isn't returned to service.
Finding a compatible donor can be the slowest part of a recovery for unusual or older models. Keep the original drive's labels intact, since they carry the details used for matching.
Advanced · head replacement · donor drive · cleanroom · head stack
Recovered data is always written to a different device than the one it came from. Writing back to the source would risk overwriting data that hasn't been recovered yet, and a failed drive shouldn't be trusted with data again anyway.
Plan for a new drive with comfortably more space than the data you need back. Labs can often supply one or work with a drive you provide.
When the recovery comes back, copy it to your own systems and make a backup before reformatting anything. For a while, the return drive may be the only copy.
Beginner · destination drive · recovered data · storage · return media
When file system records are intact, recovery brings back files with their original names, dates, and folders. When those records are destroyed, files can still be found by recognizing their content, which is called carving. But names and folders were stored in the lost records, so carved files get generic numbered names.
Carving also struggles with fragmented files, which may come back incomplete, and with formats that lack clear start and end markers. Photos, videos, and office documents often contain internal metadata, such as camera dates or document titles, that helps sort them afterward.
If a recovery includes a large folder of numbered files, sorting by file type and by embedded dates is usually the fastest way to find what matters.
Intermediate · file carving · file names · raw recovery · folder structure
Files aren't always stored in one continuous run. On a busy or nearly full drive, a large file may be split into many fragments scattered across the disk, and the file system records where each one lives.
If those records survive, fragmented files recover completely. If they're lost, recovery has to work out which fragments belong together, and some files come back incomplete, mixed with other data, or not at all. Video and large documents are the most affected.
This is why acting early and keeping metadata intact make such a difference, and why a recovered file that opens is not necessarily complete. Check important files all the way through, not just their first page.
Intermediate · fragmentation · partial files · recovery · file system
Some situations are genuinely beyond recovery. Data that has been overwritten, whether by new files, a full format, or a reinstall, is generally gone. SSD data cleared by TRIM or a secure erase is usually unrecoverable. Encrypted data without the key or password can't be read. Areas of platter scraped down by a head crash no longer hold data.
Partial outcomes are common: some files recovered intact, others damaged or missing because of where the damage fell.
A trustworthy evaluation says plainly what's possible, what isn't, and why, before recovery work begins. Be wary of anyone who promises everything before looking.
Beginner · unrecoverable data · overwrite · encryption · limits
For most desktop computers, only the drive needs to go to a lab. Laptops depend on the model: many have soldered storage, or encryption tied to the motherboard, so the whole laptop is needed. Macs with the T2 chip or Apple silicon fall into that category.
Send the whole device for phones and tablets, for anything with soldered storage, for external drives (with their enclosure, cable, and power adapter), and for NAS units or RAID enclosures if you're unsure, with every drive labeled by its slot.
When in doubt, ask before removing anything. Taking a device apart can break connectors, and removing a drive from an encrypting enclosure can make it unreadable.
Beginner · what to send · laptop · hard drive · shipping